Have you ever designed or constructed a decking installation and paving on the same project.

This question assumes the decking would be at the same finished elevation as the paving.

Do you see any long term issues with constructing a product that expands and contracts more than the product adjacent to it?

An example below is Standard Indian Sandstone and next to it Architectural Knotty Cedar

 

Views: 332

Reply to This

Replies to This Discussion

This is a good questions, as I am often asked this. Sometimes its purely down to the customer's choice and the type of decking and whether its been oiled or not.

 

For softwood I like to go for a sandstone finish, and oiling the deck yearly, to make it look new, not silver.

 

Hi Stuart

Have you ever experienced issues with the decking expanding so the decking elevation has increased over the paving thus creating a nasty lip of anything from 3 to 7mm (for example) and then in the warmer weather when the boards move the opposite way, the decking is then perhaps lower than the paving.

over to you... ;-)

 

I havent actually, as we usually do not but the paving directly to the decking. We often leave a small amount of lip and under this a shingle base for expansion, which is covered by the decking and is hidden; to the edge of the paving.

Reply to Discussion

RSS

© 2019   Created by Karl Harrison.   Powered by

Badges  |  Report an Issue  |  Terms of Service

Related Posts for Decking NetworkRelated Posts Plugin for Decking Network ForumRelated Photos Decking Network